ADSL Compliance
   - Compliant with ADSL standards
        Full-rate ANSI.413 Issue 2 and ITU G.dmt (G.992.1) standards
        Splitter less ITU G.lite (G.992.2) specification
        Annex A (ADSL over POTS) and Annex B (ADSL over ISDN)
   - DMT modulation and demodulation
   - Full-rate adaptive modem
        Maximum downstream rate of 8 Mbps
        Maximum upstream rate of 1 Mbps
   - Tone detection for low power mode
   - Supports splitter less ADSL implementation
   - Supports Dying Gasp
   - Interoperable with all major DSLAM equipment

ATM Protocols
   - WAN mode support: PPP over ATM (RFC 2364) and PPP over Ethernet
     (RFC 2516)
   - LAN mode support: bridged/routed Ethernet over ATM (RFC 1483) and
     classical IP over ATM (RFC 1577)
   - ATM Forum UNI 3.1/4.0 PVC
   - Up to 8 VCs (virtual circuits)
   - ATM SAR (segmentation and reassembly)
   - ATM AALC (adaption layer type 5)
   - OAM F4/F5

Bridge Mode
   - Ethernet to ADSL self learning Transparent Bridging (IEEE 802.1D)
   - Supports up to 128 MAC learning addresses

Router Mode
   - IP routing-RIPv2
   - Static routing
   - DNS Proxy
   - Port Forwarding
   - DHCP (dynamic host configuration protocol) server and client
   - NAT (network address translation)
   - MAPT (network address and port translation)
   - ICMP (Internet control message protocol)
   - Simultaneous USB and Ethernet operation

Wireless Features
   - Support 802.11b Wireless Access Point
   - Support 128-Bit and 64-Bit WEP encryption
   - WiFi compliance
   - Operating range
   -  Indoors: 30m (100ft.) @ 11Mbps / 50m (165ft.) @ 5.5Mbps
                     70m (230ft.) @ 2Mbps / 91m (300ft.) @ 1Mbps

Security
   - User authentication for PPP
   - PAP (password authentication protocol)
   - CHAP (challenge authentication protocol)
   - Password protected system management

Ethernet Interface
   - Compliant with IEEE 802.3 and 802.3u 10/100 Mbps